5/16" Diameter 3 Flute 1-1/8" Cut 3" Length 5/16" Round Shank Single End Square Uncoated

Top Quality End Mills – Made in North America

For the full selection of carbide end mills, Click Here

 

Brand: Skookum End Mills
Product Code: 1321157
Price: $62.10CAD $49.68CAD
Location Availability Min Qty
Skookum End Mills $100 for FREE SHIPPING 2 1
Qty:  
   - OR -   

Discounted Shipping Calculated in the Checkout

ULTRA High Performance Uncoated End Mills for Aluminum

• Special Helix Design
• Variable Pitch to reduce chatter
• 10% Extra Fine Sub-Micro Grain Carbide
with extremely high Transverse Rupture strength
• Diameter Tolerances: +0.0000”/-0.0015”

Write a review
Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

TESTIMONIALS

  • Ted
    Definitely a huge upgrade from using regular, non carbide blades. Cuts straight and easy even in hardwoods...
    24/01/2023
  • Ken Zorn
    Ordered a Flexback Bamdsaw blade. It arrived within stated time. Cuts in 3&1/4 in thick Birch were extremely smooth and required very little sanding. I would absolutely recommend this company. When needed I will order again from them...
    01/10/2021
  • Joey L.
    A used to buy sanding belts from a local supplier, who would take at least a month to bring them. Skookum usually has them to my shop in about 10 days for the same price. ..
    01/10/2019
  • Mitch
    Received order faster than expected, even just after the rush of the holidays. Would order again!..
    17/01/2019
  • Kenneth Jones
    Band saw blades arrived quickly very happy with them...
    08/03/2019
  • Dave
    So far I have only used one of the blades I ordered, but its working very well. It is by far the best blade I have used on my bandsaw. It sure does make a difference! ..
    03/01/2021
  • David perra
    Came fast nice quality I miss measured the length so I was in able to try them. But i am ordering the correct size Thank you..
    23/01/2019
  • M Byrne
    We ordered a roll of graphite and two graphite mitts. The products were as described and shipped expeditiously. If possible, it might be a good idea to develop a mitt with a heavy-duty wrist cuff. We use a wrist protector with the mitt because of the danger of the mitt slipping off the belt and..
    29/05/2020
  • Art
    I bought silicon carbide belts to make a minor slope adjustment to a small area of the concrete floor in my garage. Specifically I had water from melting snow around one front wheel of my vehicle trickle towards and pool at the wall of the garage instead trickling toward the garage door like the oth..
    05/12/2020
  • Bruno Fluet
    Very satisfied with your products, 40gr and 80gr...
    28/01/2020
Skookum Tools Ltd. © 2024