101RV8-1 Flush Trim V Groove Bit 1/2" Diameter 1" Length 1/2" Shank

1/2" Dia, Carbide Tipped, Flush Trim V Groove Bit, 2 Flutes, 1/2" Shank, 3 1/4" Length

This flush-trim "V" groove bit with ball bearings is recommended for trimming the edges of face frames flush with cabinet sides with this flush trim router bit. At the same time, cut a decorative "V" groove to conceal the seam between the frame and the case. Two flutes are ideal when fine finishing is a priority.

• Cuts most composite materials, hardwoods, softwoods, and plywood
• Can be used on most hand-held routers, and table-mounted portable routers
• Radial relief technology-enabled: Ensures minimal loss of carbide diameter when sharpening, increases tool life, and saves almost 8x the cost of regular sharpening