Respirator Silicone Small North 770030S

First time I ordered I was hesitant. But I did a small order and to my surprise I got the order writhing a week or two.. very short delivery time. Anyways I was happy with the product. I ordered again another time and had an issue with their payment system. I contacted and some one picked up and we..

These have been the best belts we've found for our needs. We are milling aluminum and use them on our belt sander to clean edges. They last much longer than other options we've tried prior! Fast shipment and great pricing. ..

Blades are great quality, run true , and cut very well. Had blades made to order . The production and shipping was fast...very satisfied with the product.!! ..

Tried Skookum 1/2 inch end mills…. Excellent quality and performance! ..

We ordered two different sizes of custom belts for a vintage sander owned by my husbands father who had passed. The belts are perfect and it’s so special to keep that sander going! The team was responsive and helpful anytime I asked questions. Thank you! ..

Ordered a Melamine Saw Blade 9" x 60 Tooth x 3.0mm Kerf x 5/8" Bore Ultima Series .Arrived in good time and was well packaged so as to arrive in great condition. But most of all it cut melamine like butter with no chipping. Great blade ..

Excellent quality bandsaw blades and extraordinary personal service from Skookum. I had the blades shipped overseas and it went without complications whatsoever. ..

The blade fits my experienced B/D hobby saw. It cuts well and I'm able to run the saw as it was intended with both tyres installed. I would like to note that both Ryan and Rob exceeded expectations in their service with me. My compliments to both. All on line vendors should take lessons. Thanks..

I have been buying bandsaw blades at Skookum for sometime. Always happy with the product. I ordered 4 special order in 2022 but didn't use them until 2024. They were the wrong length. One phone call was all it took to get free replacement blades. I offered to pay since it was my fault I hadn't check..