For general crosscutting along the grain and trimming of wood, plywood, and sizing pressboard, hardboard, chipboard, and particleboard. This blade is furnished with a 10°-15° hook angle for fast feed giving a reasonable finish.
Carbide tipped for maximum performance
This blade is furnished with a 10°-15° hook angle for fast feed giving a reasonable finish
High-quality copper plugs ensure reduction in turbulent noise by 30%
Diameter
16"
Teeth
60
Kerf (B)
.138” (3.5mm)
Bore
1"
Grind
ATB- Alternate Top Bevel
Hook Angle
10°-15°
Technology
Carbide Tipped
Material
Soft Wood, Hard Wood, Plywood, Chipboards, Particle Boards
These have been the best belts we've found for our needs. We are milling aluminum and use them on our belt sander to clean edges. They last much longer than other options we've tried prior! Fast shipment and great pricing. ..
08/03/2024
Lorne Upward
Blades are great quality, run true , and cut very well. Had blades made to order . The production and shipping was fast...very satisfied with the product.!!
..
04/10/2024
Milton
Ordered a Melamine Saw Blade 9" x 60 Tooth x 3.0mm Kerf x 5/8" Bore Ultima Series .Arrived in good time and was well packaged so as to arrive in great condition.
But most of all it cut melamine like butter with no chipping. Great blade ..
13/03/2024
Duc
First time I ordered I was hesitant. But I did a small order and to my surprise I got the order writhing a week or two.. very short delivery time. Anyways I was happy with the product. I ordered again another time and had an issue with their payment system. I contacted and some one picked up and we..
28/05/2024
Susan
We ordered two different sizes of custom belts for a vintage sander owned by my husbands father who had passed. The belts are perfect and it’s so special to keep that sander going! The team was responsive and helpful anytime I asked questions. Thank you! ..
26/01/2024
Mike E
The blade fits my experienced B/D hobby saw. It cuts well and I'm able to run the saw as it was intended with both tyres installed.
I would like to note that both Ryan and Rob exceeded expectations in their service with me.
My compliments to both. All on line vendors should take lessons.
Thanks..
15/09/2023
jack reilly
I have been buying bandsaw blades at Skookum for sometime. Always happy with the product. I ordered 4 special order in 2022 but didn't use them until 2024. They were the wrong length. One phone call was all it took to get free replacement blades. I offered to pay since it was my fault I hadn't check..
22/06/2024
Jeppe
Excellent quality bandsaw blades and extraordinary personal service from Skookum. I had the blades shipped overseas and it went without complications whatsoever. ..
15/05/2025
Blair
Tried Skookum 1/2 inch end mills…. Excellent quality and performance! ..
